-After printing, it becomes easy to use by sticking it on Drawing paper with spray glue.
-Mentions of "x1","x2" etc are the numbers of sheets. (If you need both arms or both legs etc, cut the number of double.) -Mentions of "2mm" , "5mm" etc are thickness of EVA foam.
Completion image Caution Bellow photo is a image photo aftet completing. Caution Don't print bellow photo. Caution Read "How to print".
Attention in the work
-When you uses a thing including the thinner(Bond, lacquer thinner etc) or spray, make good ventilation.
And wear a gas mask.
-When you toast mterials etc, make good ventilation.
And don't breathe smoke, don't put smoke in your eyes.
-When you dig mterials etc with Soldering iron, make good ventilation.
And don't breathe in smoke, don't put smoke in your eyes.
-Don't use fire near the things which are easy to burn such as paint, thinner
-When you finished using tools, pull an outlet.
-Read labels of materials and tools, and understand how to use.
Please support me by donation
If my tutorials supported you, please support me.
You can donate me with credit cards or PayPal etc.
I'm gonna use donation to make new props.
The donation method is displayed by clickking this banner.
Bend a PVC pipe by heat.
I reccomend a Heat gun. It's safety.
If you can't get it , use a Gas toach or a Lighter.
(Be careful about fire. If accidents happens, it's self-responsibility)
Hair dryers can't bend.
When you heat, equip globes always.
Make the edges smooth with a Soldering iron (Don't breathe in the smoke, be careful a burn).
Or, cut it by edged tools.
(Actually I used fire, but it's dangerous method. I recommend a Soldering iron
If accedents happens, it's self-responsibility)
3."Bond G17"(one of liqud glue in Japan)
This is dangerous method, it's most likely happening fire.
I wrote about this method as a archive,
However I don't recommend this.
I don't use this method now, I use other method now.
If accedents happens, it's self-responsibility.
-It'st hard to peel off.
-It can use for PVC pipe or plastic sheets.
-"Bond G17" is japanese commodity. Then you can't get it
-It needs thinner, then you must work outdoors.
-It burns easily. Don't use fire until drying, because "Bond G17" burns easily. Don' use a Lighter etc until drying.
The parts will be charred in seconds.