My profile & Contact

VAMPIRE savior、Darkstalkers 3
Lilith,Morrigan
How to make wing's nail (with templates)


Materials
[Materials for making templates]
-"Kousakuyousi"(one of hard paper in Japan) 5sheets

[Main materials]
-Plastic sheets 0.5mm thick 1sheet
-Polyester putty 100g
-Wire 50cm
-Tools and materials for a both side silicon mold
-silicon 240g
-resin 80g

[Painting materials]
-Lacquer Spray proper quantity*

*The paiting area is written in the package, refer it. Details are here.

Materials cost
1000Yen (about 100Yen = 1dollar)

Tools
-Writing implement(Pencil,eraser,ballpoint,Magic Marker,ruler)
-Scissors
-Box cutter(Use also a "Pro blade" and a "Blade breaker")
-Cutting mat
-Drill or Pinvice
-Tools for processing plastic sheets(sandpaper etc)

Convenient tools when you have
-Art knife PRO
-Super glue Accelerator

Work time
6hours

Template data
Head Waist

Attention in the work
-When you uses a thing including the thinner(Bond, lacquer thinner etc) or spray, make good ventilation.
And wear a gas mask.


-When you toast mterials etc, make good ventilation.
And don't breathe smoke, don't put smoke in your eyes.

-When you dig mterials etc with Soldering iron, make good ventilation.
And don't breathe in smoke, don't put smoke in your eyes.

-Don't use fire near the things which are easy to burn such as paint, thinner etc.

-When you finished using tools, pull an outlet.

-Read labels of materials and tools, and understand how to use.

Make the template
Make Templates from "Kousakuyousi"(one of hard paper in Japan).



Building
Cut material into the Templates form.
Cut out 0.5mm thick Plastic sheets.



Heap Polyester putty.
Wait untile hardening.

←120g ←1kg

Form by shaving with a Box cutter.


Heap Polyester putty.
Wait untile hardening.


Form by shaving with a Box cutter.


Polish with Sand paper of around 400grit.


Heap Polyester putty.
Wait untile hardening.


Polish with Sand paper of around 400grit.


Thin lacquer putty with lacquer thinner.



Paint lacquer putty thined lacquer thinner on hollows and cracks.


Polish with Sand paper of around 400grit.


Duplicate by double side silicon mold.
Details of duplicating parts with a double side silicon mold are here.
Set frames.







Pour silicon.
Details of duplicating parts with a double side silicon mold are here.





Take off frames when silicon hardens.
Take off cray.
Set frames.
Details of duplicating parts with a double side silicon mold are here.


Silicon mold was completed.
Details of duplicating parts with a double side silicon mold are here.


Duplicate by casting resin.
Details of duplicating parts with a double side silicon mold are here.



Polish with Sand paper of around 400grit.


Make hole with a Drill or a Pinvice.



Use a wire.
Cut it with Pliers.


Glue with a Liquid super glue.


Heap "Black instant glue(one of instant glue in Japan) on cracks and flaws.



Polish with Sand paper of around 400grit.


Painting
Paint.
Splay Surface Primer for casting resin.
Details of duplicating parts with a double side silicon mold are here.



Paint gray with Lacquer Spray.


Actually, I used a Airbrush too.
If you want to make light and shade, use it.
About Airbrush is here.

←私が使っているエアブラシとコンプレッサー

Please
I'm making Yotube videos.
Please watch them and please subscribe my YouTube channel.
These are new videos.




















Return to Top page