MAIL
I have facebook.
I'm writting about new props in English.

Paste Synthetic leather to a curvee surface

When a curve is slow


Cut Synthetic leather to appropriate size.
Roll a part on Synthetic leather.Cut pointo in outside of the reach + number cm.



Paste "Bond G17"(one of liqud glue in Japan) Synthetic leather and "Lion Board(Koyo Soft Board)".
Don't use fire after painting until drying, because "Bond G17"burns easily. Don' use Lighter etc until drying.
Use a broken piece of "Lion Board(Koyo Soft Board)".





Wait few minitues until half drying "Bond G17"(one of liqud glue in Japan).
Waiting time changes every season.
Touch by Finger,then it's good if finger don't has "Bond G17"(one of liqud glue in Japan).

Paste "Lion Board(Koyo Soft Board)" to center of Synthetic leather.


Paste on the whole rightly.


Pull out creases to outside.



Turn up backside.



Push by both hands strongly.


Cut off left Synthetic leather by scissors.


Paste the turned up parts with Instant glue.


Complete.


-When curve is severe


Cut Synthetic leather to appropriate size.
Roll a part on Synthetic leather.Cut pointo in outside of the reach + number cm.


Paste "Bond G17"(one of liqud glue in Japan) Synthetic leather and "Lion Board(Koyo Soft Board)"
Use a broken piece of "Lion Board(Koyo Soft Board)".


Wait few minitues until half drying "Bond G17"(one of liqud glue in Japan).
Waiting time changes every season.
Touch by Finger,then it's good if finger don't has "Bond G17"(one of liqud glue in Japan).

Paste "Lion Board(Koyo Soft Board)" to center of Synthetic leather.


Paste on the whole rightly.
Pull out creases to outside.
Turn up point witout creases and Paste with Instant glue.


Left impossible points.
It's a white part.


Leave 1mm from origin and cut off the left part.


Tunr up one side of left parts and paste.


Paste with Instant glue.


Pasting was completed.


If it turn all up, push strongly.

complete



-Example 1 - Helm
Leave at upper part.


Cut off.


Other parts are pasted on cut part.
Then breakes are hardly standed out.


-Example 2 - shoes plate


A led part is cut.


complete.


Attention at the time of work
Let's consider the following things for accident prevention and health.

-When it uses a thing including the thinner(Bond, lacquer thinner etc) and the spray, make good ventilation.
And wear a gas mask and .
<-I'm using this mask.

-When you toast mterials etc, make good ventilation.
And don't breathe smoke, don't put smoke in your eyes, wear a gas mask.

-When you dig mterials etc with Soldering iron, make good ventilation.
And don't breathe smoke, don't put smoke in your eyes, wear a gas mask.

-Do not use the lighter and tools with heart near the things which are easy to burn such as paint or thinner Bond.

-Turn off an outlet and the switch of the tool as soon as you have finished using it.

-Read labels of materials and tools carefully, and understand how to use.

Return to Top page