MAIL
I have facebook.
I'm writting about new props in English.

Cut off beautifull circle forms from EVA foam

It' not beautifull things, when you cut off circle form from EVA foam with Box cutter.
You must use appropriate tools.


-Cut off smal circles
In case of small circles to about 3cm, use Punch.
The things in right of below photo is Punch. Strike this by hammer.
And cut off.

-Store:D.I.Y shop
-Price:100Yen~ (about 100Yen = 1dollar)

There are some sized commoditty.
It's convenience if you have punch stands. Cutting mat is also good.

In case of 10mm 10mm thick EVA foam, it's difficult to cut off beautifull things.
Then, cut off 2 pieces from 5mm tchick. And paste together with Instant glue

It can make ring forms by big Punch and small Punch.

←手で押しこむだけでお手軽なタイプ←ハンマーで叩くタイプ

-Cut off big circles
Use Circle cutter, if you make Big sized circle not cut off by Punch.

I use the thing combined C-2500P and blades of "Art kinfe PRO".
This blade is neccesary.

C-2500P
-Store:D.I.Y shop
-Price:2000Yen (about 100Yen = 1dollar)

Blades of "Art kinfe PRO"
-Store:D.I.Y shop
-Price:400Yen (about 100Yen = 1dollar)

The commodity of this photo is Japanese commodity.
But, I think there must be similar things in outside of Japan.



The sharpness of this commodity's blade is so bad.
Sharpness is bad, and length is short.


Then use blades of "Art kinfe PRO" in stead of above blade.


Set blades of "Art kinfe PRO".


Adjust length of the needle and lenght of the blade to thickness of EVA foam.


These are cut things.
2mm thick and 10mm thick is cut easily.
It can cut from diameter 3cm to diameter 16cm.


Fit this parts, If you want to over 16cm. It can cut off to 23cm.
-Store:D.I.Y shop
-Price:1000Yen (about 100Yen = 1dollar)




Attention at the time of work
Let's consider the following things for accident prevention and health.

-When it uses a thing including the thinner(Bond, lacquer thinner etc) and the spray, make good ventilation.
And wear a gas mask and .
<-I'm using this mask.

-When you toast mterials etc, make good ventilation.
And don't breathe smoke, don't put smoke in your eyes, wear a gas mask.

-When you dig mterials etc with Soldering iron, make good ventilation.
And don't breathe smoke, don't put smoke in your eyes, wear a gas mask.

-Do not use the lighter and tools with heart near the things which are easy to burn such as paint or thinner Bond.

-Turn off an outlet and the switch of the tool as soon as you have finished using it.

-Read labels of materials and tools carefully, and understand how to use.

Return to Top page